  +86-13584352022                    chloe@xlholdinggroup.com
News
You are here: Home » News

Search

Contact Us

Address: No.8 Beitanghe Road, Tianning District, Changzhou, Jiangsu, China 

Tel: +86-13584352022
Fax: +86 519 80585805
E-mail: chloe@xlholdinggroup.com

News

  • Why use a raised access floor?
    2018-06-30
    A raised access floor is used to provide a means of creating a void below floor level which is capable of ensuring building services are available at their required destination. These services will typically include the following:. electrical power. Data. telecom. environmental control / air con
  • CISCA-Uniform Loading Test
    2018-06-29
    Test Procedures:The panel shall be pre-loaded to the test load. A pre-load of 50 lbs/ft² (i.e. 200 lb In the case of a panel that is 4 ft² - 2' x 2') shall then be applied and the instrumentation measuring deflection and load shall be set at zero. (Reference zero = 50 lbs/ft² pre-load)After the pre-
  • Raised Floor With “F” Edge Trim
    2018-06-28
    F" edge trim is inserted between the steel panel and the surface finish. The inserted "F" edge trim is very firm and stable. Panel with "F" edge trim creates perfect installation effect with tiny seam, which can be applied to high computer room and place where requirement on antistatic or many wires
  • ATFLOR Honed Concrete Panel: Installation Procedures
    2018-06-26
    Basic installation for ATFLOR’s Honed Concrete Panel is as outlined in ATFLOR’s Installation Manual. All access floors are all basically installed the same and all procedures should be followed. There are however two important installation differences for the Concrete panel that are not covered in t
  • Rubber
    2018-06-24
    Welbonse rubber with high wear-resisting, high elasticity and high bearing capacity, makes the ideal material to manufacture the high-quality floor. In the past ten years, we have accumulated rich experience by engaging the introduction manufacturing and application of rubber floor. Our Rubber floor
  • Total 25 pages  Go to Page
  • Go