Welbonse rubber with high wear-resisting, high elasticity and high bearing capacity, makes the ideal material to manufacture the high-quality floor. In the past ten years, we have accumulated rich experience by engaging the introduction manufacturing and application of rubber floor.

Before installation, the rubber should adapt to the environment temperature (consistent with ground temperature). In the process of adhesive natural drying, adhesive should avoid temperature changes significantly.

It adopts the technology of toughing treatment, which strengthens load capacity and static performance. Situation under the floor can be easily inspected without moving the panel, which saves labor and time as well.

Daily maintenance In daily life, clean the hair or the fiber of carpets surface with the brush or adhesive tape. Clean the carpet with the electric vacuum cleaner every two or three days.

We use technologically advance equipment in the production lines to continuously improve our manufacturing technique, ensuring the durability and aesthetic properties of these floor systems, which keeps our customers coming back time and again.

Full steel,lower plane is ST14 stretched plate,surface plane is SPCC hard steel painted with conductive antistatic epoxy resin.

The resistance to earth R2 can never be lower than the highest resistance of the individual element in the sequence: floor covering – adhesive – raised floor panels – gaskets – pedestals.

Environmental requirements for applicable fields:
Temperature:10~30℃（5~35℃ for OA raised floor ）
Relative humidity:RH30%~70%
Temperature change rate:△T≤15℃/hour ,without condensation
Vibration : no frequent vibration(resource)
Chemical environment: No high corrosion volatiles substance

Biology resistance process during the production, and seaming welding avoid any bacteria growing.

Check the room dimensions and configuration against approved drawings. Using a builder's transit or laser, shoot in the areas to receive access floor to determine how much variation there is in the level of the subfloor within the room and at the termination points, such as elevator and door sills and concrete ledges.